Wat is PDF Environment LECROY 9410 MANUAL PDF

LECROY 9410 MANUAL PDF

I REMOTE CONTROL MANUAL g g. II. II. II. | g. II g. II g. I li g a. Serial Number. May MODELS /14/20/24/30/ DUAL- AND QUAD-CHANNEL. 5 Manual Operation. Vertical Controls. Time-Base Controls. Probes. Bandwidth Limit. Trigger controls (Standard). Displaying Traces. Display Control and. See Remote Control Manual. 6FRSH ([SORUHU. Also via GPIB and RSC, the Scope Explorer software integrates the oscilloscope with Windows 95 and.

Author: Shakataxe Darisar
Country: Samoa
Language: English (Spanish)
Genre: Career
Published (Last): 17 August 2013
Pages: 228
PDF File Size: 4.40 Mb
ePub File Size: 1.31 Mb
ISBN: 521-8-22597-667-7
Downloads: 17304
Price: Free* [*Free Regsitration Required]
Uploader: Gosar

The trigger can be selected at the beginning entered or at the end exited of the specified pattern. The data and address busses are 16n bits wide.

If no trigger occurs, one is generated at an appropri- ate rate.

Teledyne LeCroy – Product Manuals – Oscilloscopes

Its main functions are: The cycle will then be exactly the same. PSD or magnitude for lecrot to While Vin and Vout are different, the capacitor is lceroy or discharged with a rate given by Iin, the integrator current, until Vout reaches Vin. The gain curve is the dependence of the front end variable gain on the 16 bit DAC. The data can also be read on the fly for roll mode purpose. TI TTL chips that have silver plated leads can have this problem. Priority is given to the main processor.

  ETIMOLOGIAS GRECOLATINAS PDF

That’s a good thought!

Usually just removing and reseating cards a few times will reduce any oxidation. The picture above shows a modulated signal top trace analyzed in frequency do- main. The line G controls the data driver output state. Power spectral density PSD in dBm. Attached to the coil are four permanent magnets to compensate for the pin cushion effect caused by the coil and the CRT.

I don’t represent LeCroy, but I do work for the Company. This forces me to as a favor of you, Gil.

LeCroy 9410 Manuals

The lower trace shows the same expansion but with 9-bit resolution. Check with an ohmmeter: Since the decoding logic had to be as simple as possible to fit into 1 PAL, the addresses are not fully decoded. Disconnect the fan cable from the F or 94XX power supply Simple English-like com- mands are used.

Four different window functions are applied to indicate their effect on leakage suppression and spectral resolution. Extrema Mode – Keeps track of time and amplitude drift by storing extreme positive and negative values, such as glitches, over a programmable number of sweeps.

  FANEM AMPLA 2085 PDF

A High level disables the outputs. A3 delivers 2 complementary outputs, one for the ADC and one for the trigger circuit. The inverse is not possible. Set the time base: The rear panel assembly can be removed from the DSO. Additive constant on first input: It is attached to the display support 3 with two screws and lock washers. Search the history of over billion web pages mxnual the Internet.

Look for loose boards or chips not firmly seated in sockets. I would start with the timebase board.

Se- lection on both line up to and field number up to 8 is possible. Priority is given to the external user. LeCroy is the registered trademark of LeCroy Corporation. I recently bought this LeCroy The dispaly processor can only read the memory to control the display. Set the bandwidth limiter ON.